With our first truck nearly finished, it was time to get going on the second. Once the chassis detail was completed, we applied a coat of paint.
And, while that was being finished, we started roughing out the body of the truck. We finished one half and marked out the hood line before removing the screws and cutting into these areas with the die grinder..
We rounded off the corners, shaping them to match the first side. Lastly, we measured and drilled in two holes for headlights — inserting two 1" dowels.
Lastly, we pressed on a thin coat of sculpting epoxy over the headlights and windshield area, remembering to include windsheild’s centre bar.
As always, we made sure to mock everything up to check our progress.
The trucks are now much closer to the final look — we just have a little sculpting to go.
